Skip to main content

940-702 Shielded Duct Monitor

Shielded Duct Monitor

940-702

The 940-702 Shielded Duct Monitor is designed to provide a direct measurement of the noble gas activity in a ventilation duct or exhaust duct in low background areas.

For some applications, the direct, in-line measurement using the 940-702, is a cost-effective alternative to withdrawing a sample of the effluent and measuring the radioactivity using an off-line monitor.

Datasheet

Speak with an Expert

Key Features

  • 2 inches lead shielding
  • Mounts directly into duct
  • Hinged rear door for detector access
  • For use with Model 943-25T Beta or Model 943-36 Gamma Scintillation Detectors
  • 137Cs check source installed in field junction box

Introduction

The Model 940-702 Shielded Duct Monitor has been designed for the direct measurement of the noble gas activity in a ventilation or exhaust duct in low background areas. For some applications, the direct, in-line measurement using the Model 940-702, is a cost effective alternative to withdrawing a sample of the effluent and measuring the radioactivity using an off-line monitor. For a nominal 12 by 12 inch duct, gaseous effluents with detectable concentrations as low as 1 x 10-7 µCi/cc may be realized.

  • Process radiation monitor
  • Airborne effluent monitor for ventilation ducts
  • Measurement of beta or gamma radiation

Applications

The Model 940-702 Shielded Duct Monitor, when used with the Model 943-25T Beta or Model 943-36 Gamma Scintillation Detector and a Model 942A Universal Digital Ratemeter (UDR) or Model 960 Digital Radiation Processor Controller, provides a radiation monitoring system for applications where the direct measurement of the radioactivity in a duct is needed. The Model 940-702 is a duct mounted, single channel detector shield, suitable for the monitoring of airborne effluents for noble gasses. The sampler is a shielded mounting fixture that provides a fixed sampling geometry for the detector. Since the active volume is fixed, the noble gas concentration measured by the detector is independent of the duct flow rate. The shield is manufactured using a 0.25 inch thick steel weldment, filled with two (2) inches of virgin lead. The lead provides shielding of the detector from background radiation. The weldment is designed to retain the lead shielding and to provide a stable mounting base for the detector. The detector is accessed for calibration or replacement via a hinged door located at the rear of the shield. The door is lead filled to minimize the induced ambient background radiation. The shield is designed for floor or platform mounting, and is bolted directly to the duct. The sensitive end of the detector protrudes approximately one (1) inch from the gasketed shield, and is inserted directly into the duct. An o-ring sealed mounting flange prevents the effluent, or ambient air, from exiting or entering the duct. A junction box is mounted on the top of the shield. The junction box provides a waterproof enclosure for connecting the detector to the control room readout cable. The junction box also contains a solenoid operated check source mechanism. The check source provides a method to verify detector operation from the control room readout device.

Models

Model Name

Description

940-702 Shielded Duct Monitor
We are professional and reliable provider since we offer customers the most powerful and beautiful themes. Besides, we always catch the latest technology and adapt to follow world’s new trends to deliver the best themes to the market.

Contact info

We are the leaders in the building industries and factories. We're word wide. We never give up on the challenges.

Recent Posts