FlukeBioMed
Home  |  Products  |  Rigid Endoscope Tester  |  
Contact us

DALE301 Rigid Endoscope Tester

 DALE301 Rigid Endoscope Tester
A simple-to-use, quick check for rigid endoscopes.

Finally, there is a simple tool for technical and non-technical personnel to perform a quick evaluation of most rigid endoscopes. With the DALE301, your staff diagnoses problems during incoming inspections, after complaints, pre- and post-service, and as a routine preventive-maintenance inspection.

With the DALE301, you can identify the following:

  • Broken lenses
  • Crooked rod shaft
  • Normal wear and tear
  • Internal moisture
  • Presence of contamination
  • Lens debris

  • Incoming acceptance inspection performed
  • Simple to use
  • Lightweight and companct
  • No light source or other accessories required
  • Pre-repair inspections to prevent unneeded repairs and save money
  • Post-repair inspections to verify a performed service or indicate if a repair was simply a "dusting-off"
  • Compatible with most rigid endoscopes
  • Compatible with common cameras for hard copy documentation to trend test or to compare and decument service

Specifications
Outer Diameter of Eyepiece
 31.75 mm +0 -0.1 per DIN 58105
End-Cap Inner Diameter
 No less then 120 mm
Optical Design
Focal length:  40 mm ± 3%
Refraction:  25 dpt
Material:  PMMA (Plexiglass)
Diameter:  19 mm
Focal Point Adjustment Scale
 16 cm
Maximum Diameter of Rigid Endoscope
 <10 mm
Environmental
Operating Temperature:  15 to 40 °C
Storage Temperature:  -10 to +65 °C
Relative Humidity:  95% max
Dimensions
 8.75" L x 1.75" W x 1.75" H
 (22 cm L x 4 cm W x 4 cm H)
Weight
 13.1 oz ( 370 g)
Model NameDescription
DALE301Rigid Endoscope Tester (Item #2249200)

Service Packages
Care PlansRequest a quote
Biomedical Equipment  |  Patient Simulator  |  Safety Analyzer  |  Dosimeter  |  Radiation Detector
Search Fluke Biomedical
ResourcesProducts
Find Resources

    Follow us                      Home   |   Site Map   |   Fluke Corporation   |   Terms and Conditions   |   Privacy Statement   |   Disclaimer© 1995 - 2014 Fluke Corporation